Trinity Power amplifier measurements


Some of the measurement of the NEW Trinity Power amplifier power amp done with the brand new audio analyser from Audio Precision. The measurement are with 3 curves, where by the first CH1 shows the limit of the analyser and CH12 shows 100W into 8Ohms and ch13 shows 200W into 4 Ohms. As you can see below 5kHz the measured THD&N are equal with the measurement limit.

On the other picture there is TRINITY Mono Bridge THD & Noise no load and into 8Ohm, 4Ohm and 2.6Ohm. There is almost no difference between no load and 2.6Ohms at full Output Level. FFT shows all harmonics are below 120dB even at full Output Level and a load of 2.6Ohm.