New Audiosilente Headshell


New Audiosilente headshells are made of aircraft aluminum, with a standard EIA connector and compatible with all arms that use this type of connection. Available in a black anodized or sandblasted gray finish, the correct azimuth is set by a 2.5 mm rear screw. The finger lift is made of brass or black anodized steel. 


The EIA connector is gold-plated brass or black anodized aluminum. 

Signal conducting pins are made of gold-plated brass with Delrin insulation. 

Each headshell is individually assembled and tested. 
The wire sets are based on our clips and made of phosphor bronze with double gold plating, the wires are made of copper-plated in a silver bath and have an outer sheath of soft silicone. 

All wire sets are hand soldered one by one, for perfect signal conduction. 

Combining the various parts of this headshell, you get 5 different versions with both a different look and a different weight, as follows: 
  • Gray headshell with black connector and black lift = 13.60 grams
  • Gray headshell with black connector and gray lift = 13.70 grams
  • Black headshell with black connector and black lift  = 13.90 grams
  • Gray headshell with gold connector and gold lift = 15.60 grams 
  • Black headshell with gold connector and gold lift = 15.80 grams 
Made in Italy by Audiosilente.